Datasheets MeanWell

ELG - 75 se r i es SPECIFICATION MODEL OUTPUT VOLTAGE RANGE Note.5 FREQUENCY RANGE POWER FACTOR EFFICIENCY (Typ.) AC CURRENT INPUT INRUSH CURRENT(Typ.) LEAKAGE CURRENT EMC IMMUNITY WORKING TEMP. WORKING HUMIDITY STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION MTBF DIMENSION OTHERS NOTE PACKING OVER TEMPERATURE OVER VOLTAGE 500ms, 100ms/115VAC, 230VAC 10ms/ 230VAC 10ms/ 115VAC(at full load) 47 ~ 63Hz 0.7A / 115VAC 0.45A / 230VAC 0.38A/277VAC <0.75mA / 277VAC Compliance to 20 ~ 95% RH non-condensing -40 ~ +80 ℃ , 10 ~ 95% RH ± 0.03%/ ℃ (0 ~ 60 ℃ ) 10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes 180 * 63 * 35.5mm (L*W*H) ENVIRONMENT EMC EMISSION SAFETY & EMC PROTECTION Shut down output voltage, re-power on to recover Shut down output voltage, re-power on to recover SHORT CIRCUIT 0.8Kg;16pcs/13.4Kg/0.67CUFT I/P-O/P:3.75KVAC I/P-FG:2.0KVAC O/P-FG:1.5KVAC I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 ℃ / 70% RH WITHSTAND VOLTAGE ISOLATION RESISTANCE ELG-75-24 200mVp-p 1.57 ~ 3.15A 88% 28 ~ 34V 12 ~ 24V 24V 75.6W 14 ~ 18V 85% 6 ~ 12V ELG-75-12 150mVp-p 2.5 ~ 5A 12V 60W ELG-75-42 250mVp-p 0.9 ~ 1.8A 90% 47 ~ 54V 21 ~ 42V 42V 75.6W TOTAL HARMONIC DISTORTION DC VOLTAGE RATED CURRENT RATED POWER Note.5 VOLTAGE ADJ. RANGE CURRENT ADJ. RANGE LINE REGULATION LOAD REGULATION SETUP, RISE TIME Note.6 HOLD UP TIME (Typ.) RIPPLE & NOISE (max.) Note.3 VOLTAGE TOLERANCE Note.4 CONSTANT CURRENT REGION Note.2 OVER CURRENT SAFETY STANDARDS ELG-75-36 250mVp-p 1.05 ~ 2.1A 89% 41 ~ 48V 18 ~ 36V 36V 75.6W ELG-75-48 250mVp-p 0.8 ~ 1.6A 90% 54 ~ 62V 24 ~ 48V 48V 76.8W ± 3.0% ± 0.5% ± 2.0% 21.6 ~ 26.4V 32.4 ~ 39.6V 37.8 ~ 46.2V 10.8 ~ 13.2V 43.2 ~ 52.8V 3.15A 5A 1.8A 2.1A 1.6A ± 3.0% ± 0.5% ± 1.0% ± 2.5% ± 0.5% ± 1.0% ± 2.5% ± 0.5% ± 0.5% ± 2.0% ± 0.5% ± 0.5% Adjustable for A/AB-Type only (via built-in potentiometer) Adjustable for A/AB-Type only (via built-in potentiometer) COLD START 50A(twidth=350 s measured at 50% Ipeak) at 230VAC μ ; Per NEMA 410 MAX. No. of PSUs on 16A CIRCUIT BREAKER 5 units (circuit breaker of type B) / 8 units (circuit breaker of type C) at 230VAC MAX. CASE TEMP. Tcase=+85 ℃ Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, light industry level (surge immunity Line-Earth 6KV, Line-Line 4KV); EAC TP TC 020; KC KN15 , KN61547 (Please refer to "STATIC CHARACTERISTIC" section) 100 ~ 305VAC 142 ~ 431VDC  ℃          ℃    ℃  ℃    48~75W Constant Voltage + Constant Current LED Driver 95 ~ 108% Hiccup mode, recovers automatically after fault condition is removed Constant current limiting, recovers automatically after fault condition is removed PF ≧ 0.97/115VAC, PF ≧ 0.95/230VAC, PF ≧ 0.92/277VAC@full load (Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section) THD< 20%(@load ≧ 50%/115VC,230VAC; @load ≧ 75%/277VAC) (Please refer to “TOTAL HARMONIC DISTORTION(THD)” section) No load power consumption <0.5W for Blank / A / Dx / D2-Type NO LOAD / STANDBY POWER CONSUMPTION Standby power consumption <0.5W for B / AB / DA-Type Tcase=-40 ~ +85 ℃ (Please refer to “ OUTPUT LOAD vs TEMPERATURE” section) UL8750(type”HL”), CSA C22.2 No. 250.13-12; IEC/EN/AS/NZS 61347-1, IEC/EN/AS/NZS 61347-2-13 independent, EN62384; ;IP65 or IP67; ; EAC TP TC 004;BIS IS15885(for 12B/24B/36A/42A/48A only) GB19510.1, GB19510.14 KC61347-1,KC61347-2-13 approved EN55015,EN61000-3-2 Class C (@load ≧ 50%) ; EN61000-3-3; GB17743, GB17625.1;EAC TP TC 020; KC KN15,KN61547 1172K hrs min. Telcordia SR-332 (Bellcore) 331Khrs min. MIL-HDBK-217F (25 ℃ ) 60W 48W 60W 60W 60W 200VAC ~ 305VAC 100VAC ~ 180VAC DALI STANDARDS File Name:ELG-75-SPEC 2020-04-08 Compliance to IEC62386-101,102,(207 by request) for DA Type only